i was looking at the i/o of the microdec and it looks like it's a 50 kohm instrument out suitable for a studio amp. Would think one could use a DI box to adjust it to about 100 ohms for an audio input into a computer or consumer audio product....(?)
The other approach might be to use the R & L Head Phone out - I can see that on the board...is that suitable?
- It is currently Sat Jun 25, 2022 6:40 pm • All times are UTC - 8 hours [ DST ]
DI'ing into a computer or consumer audio product
3 posts
• Page 1 of 1
DI'ing into a computer or consumer audio product
by waterman » Mon Sep 20, 2010 11:33 am
Last edited by waterman on Mon Sep 20, 2010 2:31 pm, edited 1 time in total.
- waterman
- Posts: 5
- Joined: Thu Sep 16, 2010 4:26 pm
Re: DI'ing into a compter or consumer audio product
by guest » Mon Sep 20, 2010 12:59 pm
the output of 1/4" jacks is 100ohm
so it can drive consumer products or headphones
at least until you start turning the volume down
then it maxes out at 2.5kohm
so it can drive consumer products or headphones
at least until you start turning the volume down
then it maxes out at 2.5kohm
- guest
- Site Admin
- Posts: 449
- Joined: Thu May 20, 2010 11:58 pm
Re: DI'ing into a computer or consumer audio product
by waterman » Mon Sep 20, 2010 3:04 pm
yes indeed. it works with an amp or straight into a consumer product. thanks!
- waterman
- Posts: 5
- Joined: Thu Sep 16, 2010 4:26 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest