two things about programming

two things about programming

Postby mcanulty » Thu May 20, 2010 11:15 pm

May 15

there are two special things about programming
1. the dip header with jumper needs to be removed - replace when done and programming header is removed
2. pin1 of the programming header is the lower right corner - its the solder pad that is square - you can look at the bottom of the board to verify
mcanulty
Site Admin
 
Posts: 63
Joined: Thu May 20, 2010 10:46 pm

Return to Software

Who is online

Users browsing this forum: No registered users and 1 guest


cron