general question about microdec

general question about microdec

Postby jcorral79 » Sat Mar 30, 2013 2:49 pm

I recently purchased the MICrODEC kit and assembled it using the instructions I found on the website. As far as I can tell, there aren't any solder points that touch each other. I connected my phone to the input and my headphones to the output. I played music on my phone and I was able to hear it, adjust the gain and level, but didn't notice any difference when I changed the effect. So my question is....is it possible to test the MICrODEC this way or do I actually need to have an electric guitar and a speaker to enjoy the effects? Thanks in advance.
jcorral79
 
Posts: 2
Joined: Thu Mar 14, 2013 7:56 am

Re: general question about microdec

Postby guest » Sat Mar 30, 2013 10:45 pm

it should work with any audio signal.

turn the mix knob to full wet, and listen for sound coming out. if any sound comes out, then the microdec is processing the audio.
guest
Site Admin
 
Posts: 449
Joined: Thu May 20, 2010 11:58 pm


Return to MICrODEC General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest


cron