Bluetooth shield

Bluetooth shield

Postby terr » Sat Oct 26, 2013 4:15 pm

Would it be possible to attach a bluetooth shield to the Arduino once the Stomp Shield is attached?
terr
 
Posts: 4
Joined: Sat Oct 26, 2013 4:10 pm

Re: Bluetooth shield

Postby guest » Sun Oct 27, 2013 11:43 am

this depends on 2 things: 1. what pins does the bluetooth shield use? this is probably just the tx/rx pins, so probably ok. 2. how much CPU does it take up? this is dependent upon what you want them to do as well. if you just want to stream audio over bluetooth from the analog input of the arduino, then its fine. if you just want to have parameters on processed audio changed by inputs that come every so often from bluetooth, that is probably also doable. but if both functions are getting used heavily, then there wont be enough CPU time.
guest
Site Admin
 
Posts: 449
Joined: Thu May 20, 2010 11:58 pm

Re: Bluetooth shield

Postby terr » Sun Oct 27, 2013 1:30 pm

That's great thanks. As far as I know the bluetooth receiver will just use the TX/RX pins. I am planning on changing the audio processing parameters ONLY via bluetooth so hopefully that won't put too much of a load on the CPU. Thanks again.
terr
 
Posts: 4
Joined: Sat Oct 26, 2013 4:10 pm


Return to Stomp Shield

Who is online

Users browsing this forum: No registered users and 1 guest


cron