Protecting the mic

Moderator: guest

Protecting the mic

Postby Altitude » Tue Dec 10, 2013 5:51 pm

2 part epoxy putty is your friend :)

Image
Altitude
 
Posts: 8
Joined: Tue Dec 10, 2013 5:11 pm

Re: Protecting the mic

Postby guest » Tue Dec 10, 2013 9:50 pm

that looks nice. did you cast it in something?
guest
Site Admin
 
Posts: 449
Joined: Thu May 20, 2010 11:58 pm

Re: Protecting the mic

Postby Altitude » Wed Dec 11, 2013 5:50 am

nope, just packed it all in there and rolled on some shiny paper. Handy stuff, dries rock hard
Altitude
 
Posts: 8
Joined: Tue Dec 10, 2013 5:11 pm

Re: Protecting the mic

Postby Yetzederixx » Tue Jul 08, 2014 2:56 pm

I managed to cut down the plastic that encases the jack, sacrifice a jumper wire, and fit all the electronics back into what was left of the plastic case. I'll drop a pic when I get a chance.
Yetzederixx
 
Posts: 9
Joined: Tue Jul 08, 2014 2:45 pm

Re: Protecting the mic

Postby guest » Wed Jul 09, 2014 10:05 am

cool, id like to see that!
guest
Site Admin
 
Posts: 449
Joined: Thu May 20, 2010 11:58 pm

Re: Protecting the mic

Postby Toney » Tue Dec 16, 2014 6:05 am

I measured the voltage on the signal/GND, and it has appropriate polarity.

________________________________
Get 70-646 - actual tests for test king and 201-01 - braindumps - study with 100% callutheran.edu guaranteed. Our high quality fcc prepares you well before www.pittstate.edu in the final exams of Southern California University of Health Sciences.
Toney
 
Posts: 1
Joined: Tue Dec 16, 2014 5:51 am


Return to BootlegMIC

Who is online

Users browsing this forum: No registered users and 1 guest


cron