Page 2 of 2

Re: Encasing Blueprints

PostPosted: Tue Jan 24, 2012 9:20 am
by guest
you may not need the pullup resistor
so if its working without it
dont worry

if youre running the opamps off a single supply
do you have any bias setting resistors
to move the voltage up to 1/2vcc

Re: Encasing Blueprints

PostPosted: Tue Jan 24, 2012 10:50 am
by mitcho
hmm... no.. i just went after this schematic
Image
taken from the TDA2822M datasheet http://www.datasheetcatalog.org/datasheet/SGSThomsonMicroelectronics/mXqwxzy.pdf

Re: Encasing Blueprints

PostPosted: Wed Jan 25, 2012 3:11 am
by guest
i had looked up the wrong datasheet
that circiut is fine for small input signals

the datasheet also listed a bunch of other chips
that are used in portable cassette players
perhaps they would be useful as well